![]() You’ll need access to your car’s OBD-II port to install the Navdy hardware. If it’s not easily accessible, installation will be difficult. After spending 40 years and unspeakable amounts of investor money to make his dream a reality, Paul Moller’s flying car is finally available for purchase. Shop for car seat stroller combo online on Target.com. Find car seat stroller combo at Target.BOB REVOLUTION OWNER'S MANUAL Pdf Download. BOB REVOLUTION OWNER’S MANUALHandlebar. Handlebar Release Lever. Rear Canopy Flap. Seat Recline Adjusters. Slider Latch. Seat Back Pocket. Shock Absorber. Shock Release Button. Frame Release Handle. Fig. 1. Anatomy of the. Wrist Safety Strap. BOB Revolution. Stroller. Parking Brake. Swing Arm. BOB is a company that produces high quality products, which encouragea healthy, outdoor, car- free life- style. In addition to strollers, we alsomake single- wheeled cargo trailers for bicycles. See www. bobgear. Before attempting to assembleor use your new stroller, read and understand these operatinginstructions completely to insure proper assembly and operation. If you are unclear on any point, contact your dealer or BOB beforeuse. WARNINGSNever leave children unattended in the stroller. Failure to properly assemble or install the quick release wheels onthis stroller may result in the wheels becoming detached whilemoving and a subsequent loss of control of the stroller. Always use seat harnesses to avoid serious injury to children fromsliding or falling out of stroller. Never allow occupants to stand in stroller. The parking brake is not designed as a stopping brake. The brakeshould not be used to slow or stop the stroller. The brake is intendedto park the stroller on flat surfaces, not on inclines. Never leaveyour children in the stroller unattended with or without the parkingbrake set! Do not strap parcels or bags to the handle as it affects the balanceand stability of the stroller and can cause it to tip over backwards. The maximum carrying capacity of the stroller is 7. Do not place sharp objects in the seatback pocket as your childleans against this and can be injured as a result. When starting out, always make sure that your kid’s hands and feetare away from wheel spokes. The stroller is not equipped for use after dark. If you intend to useit at night, we recommend installing reflectors and a lighting systemavailable through your local bike shop. We do not recommend wearing roller skates or in- line skates whilepushing stroller. Always use wrist safety strap. Never run with the stroller in Swivel Mode (see section 6)Do not use stroller on stairs or steep inclines. Stroller can tip over,resulting in injury. Never pull a loaded stroller backwards up stairs. Doing so coulddamage the suspension system – leading to frame failure and seriousinjury to the user and/or the occupants. BOB IS NOT RESPONSIBLE FOR INJURY, DAMAGE, OR FAILURETHAT RESULTS FROM OWNER’S FAULTY ASSEMBLY ORMAINTENANCE AFTER SHIPPING. AGE RECOMMENDATIONS: It is recommended that your child be a minimum of 6 to 8 weeks oldbefore riding in the stroller. Young babies incapable of holding theirhead up must be provided additional head and neck support to ridesafely. For jogging and off road use, children should be at least 6 to. Children develop at different rates. Consult with your pediatricianregarding the suitability of the stroller use with your child. Canopy Drawstring. Sun Canopy. Seat Pockets. Point. Safety Harness. Foot Well. Swivel Lockout Knob. Tracking. Adjustment Knob. Low Boy. Fork. Cargo. Swing. Pouch. Arm. Pivot. ASSEMBLY INSTRUCTIONS: Reference Fig. UNPACK: Remove stroller and stroller wheels from packaging. Plastic packaging material was used toprotect the front fork dropouts, the frontwheel axle quick release, handlebarrelease levers and the metal shockbrackets. Remove these plasticpieces. SWINGARM: Rotate theswingarm away from the frontof the stroller until the shocks. Shockengage in the first position (Fig. Release. 2). The shocks’ locking pins will. Position 1. Button“snap” and lock into position 1. Position 2. 33 HANDLEBAR: Rotate the. Fig. 2stroller handlebar up to the fully. Swingarm in unfolded positionopen position. Slider Latches willwith shock in position 1. Fig. 3). 4. 4 REAR WHEEL: Place the rearwheel quick releaselever in the openposition, as shown. Handlebar Releasein Fig. Insert the. Leverrear wheel’s stubaxle into the hole inthe rear dropout. If. Slider Latchthe axle does not. Fig. 3. Handle in the unfolded position. Fig. 4) by hand. Re- insert the axle. Quick Releasefully into the rear. Lever In Fully. Open Positiondropout until theaxle shoulder orsnap ring on theaxle comes incontact with the. Adjusting Nutdropout (Fig. Move the quick. Fig. Rear wheel Quick Release withrelease lever to thelever in open position. Fig. 6). The word. CLOSE should be clearly visible and the quick release lever shouldbe pointing up towards the seat. When properly adjusted, it will requireconsiderable pressure (8. If you(8. 00) 8. 93- 2. Phone: (8. 05) 5. Fax: (8. 05) 5. 43- 8. BOB Trailers, Inc. Sacramento Dr. 4), andadjust the adjustingnut (clockwise totighten,Dropoutcounterclockwise to. Fig. Move the. Rear wheel installed withsnap ring or shoulder contacting dropout. Fig. NOTE: Follow all instructionsexactly. If you areunsure how tooperate the quickrelease, consult yourdealer or contact. BOB. Quick. Release. FRONT WHEEL: Fig. Quick release in theclosed position. The front fork’s dropouts are slotted to receive the front wheel (Fig. Slide the wheel into the dropouts so that the quick release leveris on the left hand side of the stroller when the fork is rotated forwardand locked in the fixed jogging position (see section 6). Make surethe wheel is centered in thefork and that the axle is. Tire/Wheel. Quicktouching the top of the drop out. Release. Leverslot. Adjusting. Securely tighten the wheel in. Nutplace as follows: With the quickrelease lever in the openposition (Fig. Camadjusting nut (clockwise) until. Housingit comes in contact with the. Fig. 7stroller dropout. Move the. Front wheel Quick Release Anatomy. Fig. Thisshould require significantpressure. If you do not feelsignificant resistance, turn the. Forkquick release lever back to theopen position (Fig. Dropoutstighten the adjusting nut by oneor two more turns in the. Quick. Releaseclockwise direction. Move the. Leverquick release lever toward theclosed position (Fig. Front wheel dropouts shownword CLOSE should be clearlywith wheel in correct position. Quickvisible and the quick release. Release lever perpendicular to dropout. It should requireconsiderable pressure (8. Quickinch- pounds) to close the lever. Releasewhen properly adjusted. NOTE: Lever. Fork. Follow all instructions exactly. If you are unsure how tooperate the quick release,consult your dealer or call BOB. SWIVEL LOCKOUT: Yournew Revolution Stroller canbe used in one of two modes. Dropout. The stroller can be used as a. Fig. 9swiveling wheel stroller (swivel. Quick Release in closedposition and parallel to fork leg. MA0. 50. 6is in the unlocked position (Fig. Or, it can be used as a fixed wheelstroller (Jogging Mode) when theswivel lockout knob is in the locked. Swivelposition (Fig. To change from. Lockoutthe swiveling wheel mode to the. Knob(Unlockedfixed wheel mode, lift and slide the. Position)lockout knob (Fig. Then release. Forkthe knob, and it will snap down. Fig. 1. 0Next, rotate the fork until the pin. Swivel lockout - unlocked positionengages and locks the fork inposition. You are now ready to usethe stroller in the fixed wheel mode. To change the stroller back to theswivel mode, lift the lockout knoband rotate it to the left. This willfree the fork, and the stroller is now. Swivel. Lockoutready to use in the swivel mode. Knob(Locked. TRACKING ADJUSTMENT: 7. Position)It should be noted that all fixedthree wheeled vehicles can be. Forkeasily influenced to deviate from. Fig. 1. 1a straight path. In some cases. Swivel lockout - locked positionstrollers can have or develop atendency to pull to the right/left dueto many different factors including tire pressure, wheel installation,road conditions and manufacturing tolerances. If you find your BOBstroller to significantly track or pull to the left or right while in thejogging configuration during use on flat terrain, follow the sequenceof instructions below. Top View Of Stroller. Wheel axles. Stroller pulls. Stroller pullsperpendicularto leftto rightto straight lineo. Fig. 1. 2Stroller roll test. Tracking Adjustment Instructions: Note: Tracking adjustment can only be performed with the stroller forklocked out (jogging configuration). Roll test the stroller as describedbelow. It is recommended you have someone assist with this task inorder to catch and return the stroller. Empty the stroller. Do not roll test with a child or any occupantin the stroller. Find a location on level ground approximately 1. It is helpfulto use an existing straight- line as a frame of reference such as theedge of the sidewalk or a painted line in a playground. Align the stroller so the rear wheel axles are perpendicular to thestraight line. Push and release the stroller, trying carefully not toinfluence its direction to the left or right, so it rolls straight down thetest path. This step should be performed more than once to makesure the stroller was not biasedleft or right by the pushing action. If the stroller consistently pullsto the left or right when pushedstraight, proceed with the steps. Trackingbelow until tracking is satisfactory. Adjustment. Fig 1. Tracking adjustment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
August 2017
Categories |